Pump centrifugal,diesel,50cbm/hr@20m TMH

General Description:
Centrifugal pump, diesel driven, with a capacity of 50 m3/hr
at 20 m Total Manometric Head.

Technical Specifications:
Self-priming centrifugal pumping set, capacity 50 Cubic Metres per hour at around 2900 RPM, at 20 metre TMH (Total Manometric Head) for 1-m suction head.
Available in a wide range of pumping capacities.
Mounted on a trolley with 2 wheels and a handlebar, it can also be mounted on a sturdy steel skid with carrying handles (field office must specify choice).

The skid has pre- drilled holes to facilitate bolting it to a foundation.
The pump is coupled directly to a diesel engine of matching power requirement.
The pump casing, shaft and impeller are made from cast iron, and the water seal on the shaft is mechanical.
The suction inlet and discharge outlets are available in various diameters depending on the pumping capacity of the pump; these vary in size such as: 50, 65, 75, 100 and 150 mm.

When a specific pump is ordered the supplier will provide the most efficient diameter of inlet/outlet pipes with the pump. However, if the field office requires a specific size of pipe or specific adapter this must be clearly specified when placing the order.
An air-cooled, direct injection, diesel engine powers this range of pumps and is available in one of three choices of starting devices: rope starting, recoil starter, or electric starter with 12 volt battery and charging alternator (field offices must clearly specify the required means of starting at time of ordering).

The engine is fitted with a speed control governor, a fuel tank with sufficient capacity for (2 - 3) hours of continuous normal operation.

Two choices of air filters are also available: a dry type or oil bath type (field offices must specify air filter requirement at time of ordering).
The engine is also fitted with a sound proof muffler and the liners are re-borable.

Available in 50, 75, 100 or 150 mm diameter and with matching bayonet type couplings to match the pump inlet/outlets
(Field office should specify if specific diameters are needed).
Hose lengths: Field office should specify the lengths required at time of ordering if other than those mentioned below.

Supplied with:
1 x suction hose, semi-rigid, 5 m.
1 x delivery hose, 20 m.
1 x stainless steel strainer.
1 x non return valve.
1 x tool kit for installation, operation and maintenance.
1 x oil container, 4 litres, for diesel engine.
1 x spare parts kit for 2000 hours of normal operation, including various filters, seals and one injector.

Packaging and labelling:
The pump is packed in a wooden box.

Accessories/Spare parts/Consumables:
A spare part kit is included with the pumping set.

Weight/Volume/Dimensions:
Estimated weight: 150 kg
Estimated volume: 1.2 m3

Instructions for use:
The pumping set is used for pumping surface water, maximum suction lift 7 metres, from shallow wells, rivers, lakes.